Need some direction as I've hit a major brick wall! I've downloaded both the Unlimbited Phoenix and the Blender app. However, when I try to import the Phoenix to Blender I get an error message. All I get is a cube in the center and a pyramid like structure on the left side of Blender. I've watched numerous videos but none seem to address my problem. Most are about sizing from a photo. Also can't open the Unlibited-Phoenix without an app.
The directions say for the purpose of submitting hand, in order to be approved, increase the size of the Unlimbited-Phoenix to 125-135% because the software which is posted makes a hand which is too small.
I'm not computer illiterate but I can't figure out how to increase the size appropriately and where and how one manages this. I have a printer all lined up, so this is a step I must have before I can print. Any help would be greatly appreciated!!
General discussion related to getting started.
1 post • Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 1 guest