submitting my first hand to become certified--need help!

General discussion related to getting started.
Posts: 2
Joined: Wed Jul 18, 2018 6:12 pm

submitting my first hand to become certified--need help!

Postby sclandau1 » Tue Aug 07, 2018 1:16 am

Need some direction as I've hit a major brick wall! I've downloaded both the Unlimbited Phoenix and the Blender app. However, when I try to import the Phoenix to Blender I get an error message. All I get is a cube in the center and a pyramid like structure on the left side of Blender. I've watched numerous videos but none seem to address my problem. Most are about sizing from a photo. Also can't open the Unlibited-Phoenix without an app.

The directions say for the purpose of submitting hand, in order to be approved, increase the size of the Unlimbited-Phoenix to 125-135% because the software which is posted makes a hand which is too small.

I'm not computer illiterate but I can't figure out how to increase the size appropriately and where and how one manages this. I have a printer all lined up, so this is a step I must have before I can print. Any help would be greatly appreciated!!

Many thanks.

Return to “General Getting Started”

Who is online

Users browsing this forum: No registered users and 1 guest