Phoenix / Raptor / Something else?

General discussion related to getting started.
Posts: 1
Joined: Thu Jan 31, 2019 12:18 am

Phoenix / Raptor / Something else?

Postby DMeNTED » Thu Jan 31, 2019 12:29 am

Hey guys -

First off I just found out about this group and think its awesome!

I want to get involved and am reading through all the getting started docs... question is which prosthetic is the best for a first print?

Phoenix or Raptor? Or is there something better?

Printing on a Prusa MK2.

Thanks in advance!

Posts: 18
Joined: Mon Jun 25, 2018 12:03 am

Re: Phoenix / Raptor / Something else?

Postby airscapes » Thu Jan 31, 2019 9:10 pm

Phoenix V2 to me would have been better than the unlimited as there are good written instructions for the v2 and lots of well made how to videos.
Good luck, there are many people who what to fabricate and assemble but a real shortage of people to fit and run the show. I never did do anything with Enable as the cases I signed up for never got going.. Did however make a Kwawu V2 arm for a coworkers daughter.. that is a hard one in an 11 year old's size!

Return to “General Getting Started”

Who is online

Users browsing this forum: No registered users and 1 guest