Elbow powered hand

Questions and answers about printers, software, modeling, and all other aspects of making hands
dstudio
Posts: 1
Joined: Fri Jan 13, 2017 1:24 pm

Elbow powered hand

Postby dstudio » Fri Jan 13, 2017 1:39 pm

Hi, I printed a elbow powered hand for 14 yr kid. the prints have come out fine but have issue with finger movement. the top joints move as they should but the lower joints (connected to palm) only move partially. any advice?

FinerMotor
Posts: 3
Joined: Sun May 20, 2018 1:52 pm

Re: Elbow powered hand

Postby FinerMotor » Sun May 20, 2018 2:25 pm

Hello,

Which hand are you printing? Assuming one with cabling, are you using fishing line that stretches? This could cause it to stretch when flexing initially moving the top of the digit and then stretching as the lower digits add more resistance. I would suggest moving to a line that has less flex in it if this is the case.

Good Luck,
Nicholas
Broadcasting electronic projects and 3D printing on Twitch as "BuildABore"
Electrical Engineering student


Return to “Technical Q&A”

Who is online

Users browsing this forum: No registered users and 1 guest