Using Files

Questions and answers about printers, software, modeling, and all other aspects of making hands
zakw
Posts: 2
Joined: Fri May 08, 2015 7:21 pm

Using Files

Postby zakw » Mon Nov 16, 2015 8:18 pm

I downloaded zip files and open in Inventor just fine. However when I try to print I am no able. I've tried creating .stl but am not making progress. Any suggestions?

Thanks,

Bill

Peregrine Hawthorn
Posts: 64
Joined: Mon Feb 16, 2015 5:49 am

Re: Using Files

Postby Peregrine Hawthorn » Mon Nov 16, 2015 8:23 pm

Are you using a slicer line Slic3r or Cura? Slivers convert .stl files into g-code, a kind of road map used by 3D printers to construct an object.

If you're doing all that, and it's still going wrong, we'll need more information on what, exactly, you're printing on, and what's going wrong.

EDIT: Moved to Technical Q&A
Heavy duty hand user, and co-designer of the Talon.

I break hands and then tell you how I did it.


Return to “Technical Q&A”

Who is online

Users browsing this forum: Baidu [Spider] and 1 guest