Reverse Dovetail Thermo-gauntlet

For design validation in preparation for merging into publicly released devices
droomurray
Posts: 69
Joined: Mon Feb 16, 2015 4:04 pm

Reverse Dovetail Thermo-gauntlet

Postby droomurray » Mon Oct 05, 2015 9:42 am

All,

Following the release of the thermo-form reverse dovetail gauntlet can we use this thread to capture any feedback / problems etc.

The release is here :- http://www.teamunlimbited.org/thermo-form-gauntlet/

Regards,

Drew and Stephen.

jameshs
Posts: 11
Joined: Mon Feb 16, 2015 7:22 am

Re: Reverse Dovetail Thermo-gauntlet

Postby jameshs » Mon Oct 05, 2015 2:44 pm

I am getting a slightly off artefact on the holes.

looks good in S3D
writs hole 001.JPG
writs hole 001.JPG (17.95 KiB) Viewed 1153 times


then when I slice I get a small diaphragm across the hole

writs hole 002.JPG
writs hole 002.JPG (18.15 KiB) Viewed 1153 times


Will be easy enough to remove, but just curious as to what it was there for.

Am printing the jig upside down as this seems to work best for the supports.

Look forward to playing with the result :)

James
James


James Holmes-Siedle
jhs@allclear.co.uk
www.allclear.co.uk

droomurray
Posts: 69
Joined: Mon Feb 16, 2015 4:04 pm

Re: Reverse Dovetail Thermo-gauntlet

Postby droomurray » Mon Oct 05, 2015 2:45 pm

James,

I think this is a bug in s3d, I get exactly the same with s3d.
I did run the models through netfabb and it picked up no problems.

Drew.


Return to “Beta Testing”

Who is online

Users browsing this forum: No registered users and 1 guest