Sizing Issues

For discussion of arm designs.
stevepalma
Posts: 2
Joined: Mon Feb 16, 2015 10:11 pm

Sizing Issues

Postby stevepalma » Tue Feb 17, 2015 7:22 pm

Hello everyone, I would like to reach out for some assistance with a RIT arm design for Violet, she is about 22 months old and I have been having continuous problems with sizing and with threading line through the palm area the palm has been printed at 75%, and 85%, anything larger will be too big, the problem I am having as you can see in these photos, is the palm is not lining up with the forearm extender, all pieces have been reduced equally, also the tendon holes are becoming too small for any type of lines to go through. I am working with .STL files so as I am not able to manipulate the design. I am using both slicr3 and S3D, both results are the same, does anyone have any suggestions? Pictures have been posted to enable R&D.

stevepalma
Posts: 2
Joined: Mon Feb 16, 2015 10:11 pm

Re: Sizing Issues

Postby stevepalma » Wed Feb 18, 2015 11:57 am

This sizing issue is currently being resolved. I will keep you post of the solution,thank you


Return to “Arms”

Who is online

Users browsing this forum: No registered users and 1 guest