For discussion of arm designs.
2 posts • Page 1 of 1
Has anybody run the Kwawu SCAD configuration file from thingiverse? When I renerate the STLs the threads on the wrist bolt are reverse of the threads in the palm (i.e. the wrong direction). Anybody else had this issue? Anybody have a SCAD file that doesn't do this?
was it a left or right hand.. have not done so but waiting for measurements and plan on trying this arm. Did you do one part as right hand and the other as left.. would think both sets of thread would be right handed.. but maybe not?
Who is online
Users browsing this forum: No registered users and 1 guest