I modeled this new bracer and whippletree for the Raptor Reloaded based on it's original bracer, in an effort to make the bracer more aesthetically pleasing and merge the tensioner box with the bracer (can someone explain to me why they're separate? I assume because of printing orientation).
The velcro slot is 30mm wide, and velcro could either be threaded through both as a single loop or separately.
Do you think it would work? I don't have a 3D printer to test it out myself.
- front.jpg (221.36 KiB) Viewed 2852 times
- back.jpg (200.07 KiB) Viewed 2852 times
- top.jpg (181.72 KiB) Viewed 2852 times
I also think it should be printed upright because of the holes in the tensioner, with slight support so it doesn't fall down (pictured)
- support.jpg (158.53 KiB) Viewed 2852 times
Here are the .step and .stl files http://www.thingiverse.com/thing:849407