Have you used PET filament? Does it work?

Questions and answers about printers, software, modeling, and all other aspects of making hands
Posts: 4
Joined: Sun Apr 22, 2018 8:05 pm

Have you used PET filament? Does it work?

Postby MillionWavesProject » Sun Apr 22, 2018 8:11 pm

Has anyone tried PET to make a hand? Curious if it works.


Posts: 10
Joined: Mon Jun 25, 2018 12:03 am

Re: Have you used PET filament? Does it work?

Postby airscapes » Tue Jul 31, 2018 8:48 pm

not sure anyone still reads this but yes, I used PETG for some of the parts of the and and the pins. Worked well but was a problem for the thumb adjuster pin. This was on the v2 hand. When messing with the hand (was an approval hand) I tired to pick up something very heavy and the fishing line CUT through the end of the adjuster like a knife. The PETG is soft in comparison to ABS and PLA but flexible. This makes is a great plastic for many mechanic part but that adjuster has a very small amount of plastic between the end of the pin and the hole.. I reprinted this adjuster in EPA nylon which I think I will use try out for all pins on my next approval hand.
Hope that helps someone!

Everything white is PETG, Black is ABS and red and gray PLA
hand almost done.jpg
hand almost done.jpg (101.28 KiB) Viewed 23 times

Return to “Technical Q&A”

Who is online

Users browsing this forum: No registered users and 1 guest