All arms... PLEASE HELP I NEED HELP... EMERGENCY

For discussion of hand designs.
MoniqueCummings
Posts: 1
Joined: Tue Aug 14, 2018 10:44 am

All arms... PLEASE HELP I NEED HELP... EMERGENCY

Postby MoniqueCummings » Tue Aug 14, 2018 11:07 am

I really need to know what the difficulty level of building each of these prosthetic models are? (raptor reloaded, cyborg beast, unlimbited phoenix, reborn phoenix and the phoenix arm)
Also, how long does it take to print the 3D bits of each of these models?
Finally, how long does it take to assemble each of these models?

If anyone answers, I'll buy you cake :)

Cheers,
a frantic high school student

airscapes
Posts: 13
Joined: Mon Jun 25, 2018 12:03 am

Re: All arms... PLEASE HELP I NEED HELP... EMERGENCY

Postby airscapes » Tue Aug 14, 2018 11:34 pm

Built the Unlimbited and Phoenix V2. Takes time to print, 3d printing is not plug and play. Didn't time the assembly.. stringing the fingers takes the most time.. If you have never 3d printed you should probably start with that as it is a time consuming learning curve.
Someone just posted an instructable on how to get your makers badge over in the enable Google+ group. I would suggest you join there if you can figure out how.. They don't use this forum anymore too much.
https://www.instructables.com/id/Steps- ... BLE-Maker/\

Link to google group I think.. https://plus.google.com/u/0/communities ... 6887179986


Return to “Hands”

Who is online

Users browsing this forum: No registered users and 1 guest