This Raptor Reloaded device was created by Dr. Holly Martin and Anderson Carey at The Walker School in Marietta, GA, USA.
The model was obtained from Thingiverse: https://www.thingiverse.com/thing:596966
A video can be seen on YouTube at: https://www.youtube.com/watch?v=1_oIEGzbvS0
This hand was printed on a Makerbot Replicator + at 125% using PLA filament at 35% infill density. Materials to assemble the hand were purchased as a kit from 3D Universe. No difficulties were encountered in printing or assembling the hand.
Community driven device approvals.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests